Prepare the Taper: Take a close look at the cover braid and you will see that half the strands revolve to the right and half to the left.This helps keep the core and cover secure while you are completing the splice (figure 1). Tie a Knot: Approximately 5 fid lengths from Mark X, tie a slip knot. ![]() If adding a thimble, make sure the loop is just long enough to wrap tightly around the thimble and mark accordingly. This point is where you will extract the core from inside the cover. Form the Eye: From Point R form a loop the size of your desired eye and mark the end of that loop as Mark X.Prepare the Rope: Tape the end of your rope with a thin layer of tape, then from the end of your rope, measure back 1 tubular fid length (or 2 wire fid lengths) and mark as Point R, for “reference” (figure 1).If you plan to add a thimble make sure it's handy too. Preparationīefore you start, it's a good idea to gather everything you will need – including splicing fid, tape, sharp scissors, a black marker and some sort of marlinspike or pick, along with the Class I line you want to splice. We also have Navigators for creating an eye splice with 3-strand line or a rope to chain splice if you're interested. Class I lines incorporate a braided core within a braided cover – with both the core and cover carrying an equal amount of the load – and Class I is what we will discuss splicing in this Navigator.Ĭlass I lines are usually constructed from traditional fibers such as olefin, polyester and nylon and this splice is completely different than splicing with a Class II line, so it's important to consult the manufacturer if you're not sure what line you have. ![]() With braided rope it's very important to differentiate between “Class I” and “Class II” lines. They can also be used to form rope around a thimble, which protects the rope when it's being used in conjunction with something that might chafe such as wire rope or a shackle. If you're looking for information on how to create an eye splice with double braid rope – you've come to the right place! An eye splice is used to add a permanent loop at the end of a rope, such as for a halyard or a dock line of a specific length.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |